| Electronics
The electronics of Carli Precimeter
GmbH have been developed especially to meet
the high standards of our measuring systems.
The type of electronic is chosen accor- dingly
to the application resp. process.
|
|
|
| MGK 1000 C (analog)
The MGK 1000 C unit (analog) is an economically
priced high-performance system. It can be
used with all Carli Precimeter GmbH
probes. The unit is designed for fitting
to a standard rail system. It has a LED
in the front cover instead of a display
and can be configured with an analog output
signal.
Order No.: E-MGK-1000-CA
Detailed views - Product illustrations /
Technical data
Electronic
MGK 1000 C (analog)
|
|
| MGK 1000 C (Robot)
The function of the MGK 1000 C unit (robot)
replaces the electrode on the bionic arm of
the robot.
This unit is designed for contactless detection
of the melt surface and has 3 adjustable
switch points. The switch points can be
configured as follows.
• melt recognition
• working level
• emergency switch-off
Order No.: E-MGK-1000-CR
Detailed views - Product illustrations
/ Technical data
Electronic MGK 1000 C (Robot)
|
|
| |
|
| |
| |
MGK 1000 C (Switch)
The MGK 1000C unit is an economically priced
high-performance system. It can be used with
all Carli Precimeter GmbH probes.
The unit is designed for fitting to a standard
rail system. It has an LED array in the
front cover instead of a display and 1-5
adjustable switch points are possible.
Order No.: E-MGK-1000-CS
Detailed views - Product illustrations
/ Technical data
Electronic
MGK 1000 C (Switch)
|
MGK 1002
The MGK 1002 unit was developed to process
dual measuring ranges such as:
• dual chamber systems
• filter control
• two levels are measured one above
the other (as in aluminium or magnesium
electrolysis)
The equipment is designed for rail mounting
and possesses two digital displays.
Order No.: E-MGK-1002
Detailed views - Product illustrations
/ Technical data
Elektronik
MGK 1002
|
 |
MG 2001
The unit MG 2001 is an analog all-round electronic
device in a normal housing.
A LCD display and 4 trimming devices are
located on the front plate to configure
the settings 0%, 100% in addition to limit
1 and limit 2.
The equipment is suitable for intermediate
installation, particularly in switchgear
cabinets or wall housings.
Order No.: E-MG-2001
Detailed views - Product illustrations /
Technical data
Electronic MG 2001
|
 |
MP 2010
The unit MG 2010 is an analog all-round micro-
processor-controlled unit.
A LED display and the keys for the configuration
input are located in the front plate.
The equipment is suitable for intermediate
installation, particularly in switchgear
cabinets or wall housings.
Order No.: E-MP-2010
Detailed views - Product illustrations
/ Technical data
Electronic MP 2010
|
 |
